2017 GMC Terrain

THIS PRELIMINARY INFORMATION COMMUNICATION PROVIDES INFORMATION TO THE TECHNICIAN ON THE STEPS TO DIAGNOSE AND REPAIR VEHICLES THAT HAVE A RESONANCE TYPE VIBRATION OCCURS BETWEEN 40 TO 60 MPH. IN MOST CASES THE ENGINE MUST BE UNDER A SLIGHT LOAD SUCH AS A/C COMPRESSOR ENGAGEMENT, LIGHT THROTTLE, AND IN 6TH GEAR TORQUE CONVERTER CLUTCH APPLIED. TECHNICIAN WILL RELAX THE ENGINE AND TRANSMISSION MOUNTS, THEN THE EXHAUST SYSTEM BY LOOSENING THE FRONT PIPE STUDS. ALSO WORK DOWN THE SYSTEM DISCONNECTING ONE EXHAUST HANGER AT A TIME. THEN TAKE THE VEHICLE ON A TEST DRIVE TO VERIFY THERE WAS IMPROVEMENT. IF ADDITIONAL STEPS ARE REQUIRED PLACE TWO SETS OF EXHAUST DAMPENERS ONE SET BEFORE AND ONE SET AFTER THE FRONT CATALYTIC CONVERTER. IT MAY BE REQUIRED TO MOVE THE PAIR OF DAMPENERS ALONG THE EXHAUST SYSTEM TO GET THE BEST RESULTS.

THIS PRELIMINARY INFORMATION COMMUNICATION PROVIDES INFORMATION TO THE TECHNICIAN ON HOW TO DIAGNOSE AND REPAIR VEHICLES THAT MAY HAVE THE ANTILOCK BRAKING SYSTEM, SERVICE TRACTION CONTROL SYSTEM, AND/OR SERVICE STABILITRAK LIGHTS ARE ON. THE ELECTRONIC BRAKE CONTROL MODULE MAY HAVE ONE OR MORE OF THE FOLLOWING DIAGNOSTIC TROUBLE CODES C0035-C0050 WITH SPECIFICALLY SYMPTOM 18, 5A, OR 0F. TECHNICIAN WILL GAIN ACCESS TO THE CORRECT WHEEL BEAR PER THE DIAGNOSTIC TROUBLE CODE THAT IS SET. IF DEBRIS IS FOUND ON THE MAGNETIC ENCODER RING IT WILL NEEDED TO BE CLEANED.

THIS PRELIMINARY INFORMATION COMMUNICATION ADVISES THE TECHNICIAN THAT ,WHEN TESTING ANY CIRCUIT FOR OPEN OR RESISTANCE, IT IS IMPERATIVE THAT ALL RELATED TERMINAL PIN FIT AND TENSION BE CHECKED WHEN THE TEST STEPS REQUIRE DISCONNECTION OF THE CONNECTOR OR COMPONENT, PRIOR TO ANY COMPONENT REPLACEMENT. ALWAYS USE THE RECOMMENDED TERMINAL TEST TOOL DURING THESE TESTS.