2025 Ford Bronco

Some 2025-2026 Bronco, Bronco Sport, F-Super Duty, Maverick, Mustang, Mustang Mach-E, Ranger and Transit vehicles may exhibit a no audio/sound condition. This may be due to the software in the audio control module (ACM). To determine if it is a software concern, disconnect the vehicle's 12-volt battery cables for 10 minutes and reconnect. If the concern is still present, continue with normal diagnostics in Workshop Manual (WSM), Section 415-00 Information and Entertainment System > General Information > Diagnosis and Testing and repair as necessary outside of this article. If the no audio/sound concern is resolved, engineering is currently working on a solution for this condition that is expected by September 2026. Replacement or reprogramming of the ACM and or audio digital signal processing module (DSP) may not resolve this condition at this time. Monitor Professional Technician System (PTS) for additional information and schedule service appointments for customers once the repair becomes available. If a customer's vehicle exhibits this concern, submit a Vehicle Concern Report.

Some 2025-2026 Bronco vehicles may exhibit various cruise control, pre-collision and/or front stabilizer bar disconnect related warning messages displayed in the instrument panel cluster (IPC) with diagnostic trouble code (DTC) U0418:86 stored in the image processing module A (IPMA) and no wheel speed sensor specific DTCs present in the anti-lock brake (ABS) module. DTC U0415:00 may also be stored in the CHCM. If a vehicle exhibits this condition, carefully inspect the rear wheel speed sensors for correct installation with the rear wheel speed sensor body seated flush against the axle housing. Repair or replace the affected rear wheel speed sensor as needed, clear the DTC, and retest. Refer to Workshop Manual (WSM), Section 206-09. If the condition persists, advise the customer that Engineering is working on a software robustness solution that is expected to be available Q2 2026. <br /><br /> This condition does not affect vehicle durability, and additional diagnosis or service is not recommended at this time. Replacement or reprogramming of the IPMA and/or ABS modules will not resolve this condition.

Some 2021-2025 Bronco vehicles built on or before 09-Sep-2025 may require replacement of the ambient air temperature sensor for various concerns. Diagnostic trouble codes (DTC) P0071, P0072, and/or P0073 may be present in the powertrain control module (PCM). A concern has been identified in TSB 26-2006 that previously instructed replacement of the incorrect ambient air temperature sensor for the vehicle application. Monitor Professional Technician System (PTS) for updates.